Yealink SIP-T40G

BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK T4X IP PHONE 20-BD5476-00
©
2017 BROADSOFT INC. PAGE 135 OF 150
account.3.anonymous_call =
account.3.anonymous_call_oncode =
account.3.anonymous_call_offcode =
account.3.reject_anonymous_call = %REJECT_ANONYMOUS_CALL_BINARY%
account.3.anonymous_reject_oncode =
account.3.anonymous_reject_offcode =
account.3.send_anonymous_rejection_code =
##########################################################################
#############
## Pickup Code
##
##########################################################################
#############
##It enables or disables the phone to pick up a call according to the SIP
header of dialog-info for account X.0-Disabled,1-Enabled.
##The default value is 0.
account.3.dialoginfo_callpickup =
##It configures the group pickup code for account X.
##The default value is blank.
account.3.group_pickup_code = %BWFAC-CALL-PICKUP-3%
##It configures the directed pickup code for account X.
##The default value is blank.
account.3.direct_pickup_code = %BWFAC-DIRECTED-CALL-PICKUP-3%
##########################################################################
#############
## DTMF
##
##########################################################################
#############
account.3.dtmf.type =
account.3.dtmf.info_type =
account.3.dtmf.dtmf_payload =
##########################################################################
#############
## Alert info
##
##########################################################################
#############
##It enables or disables the distinctive ringtones by the Alert-Info SIP
header for account X.0-Disabled,1-Enabled.
##The default value is 0.
account.3.alert_info_url_enable =
##Except T19P/T21P Models
##The default value is blank.Values range 256 characters in length
account.3.alert_info =
account.3.ringtone.ring_type =
###Only for T46G Model
##It enables or disables the phone to download the picture information for
account X when receiving an incoming call or during a call.0-Disabled,1-
Enabled.
##The default value is 0.
account.3.picture_info_enable =
##########################################################################
#############