Yealink SIP-T41P Configuration Guide

Yealink IP Phones Configuring Guide
12
3. Enter the desired values in the Static IP Address, Subnet Mask, Gateway, Primary
DNS and Secondary DNS fields respectively.
4. Press the Save soft key to accept the change.
5. Perform auto provisioning on the phone to download above configurations. For
more information on how to perform auto provisioning, refer to Downloading
Configuration Files on page 7.
To configure a static IPv6 address via CommPortal phone configurator:
1. Click on Network >IP Setting.
Make sure that the IP address mode is configured as IPv6 or IPv4 & IPv6.
2. Select Static IP Address from the Internet Port Type for IPV6 pull-down list.
3. Enter the desired values in the Static IP Address, IPv6 Prefix, Gateway, Primary DNS
and Secondary DNS fields respectively.
4. Click Save changes to accept the change.

Yealink SIP-T41P Specifications

General

Power requirements	AC 100-240V, DC 5V
Power over Ethernet (PoE)	Yes
Touchscreen	-
Display diagonal	2.7 \
Display resolution	192 x 64 pixels
Lines quantity	- lines
Phonebook capacity	1000 entries
Number of VoIP accounts	3
Voice codecs	G.711, G.723, G.726, G.729A, G.729B
Bluetooth	No
Ethernet LAN (RJ-45) ports	2
Storage temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	10 - 95 %
Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Number of handles included	1 pc(s)

Weight and Dimensions

Depth	189 mm
Width	212 mm
Height	175 mm