Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
547
Watch Dog Configuration
The following table lists the parameter you can use to configure watch dog.
Parameter
static.watch_dog.enable <y0000000000xx>.cfg
Description
It enables or disables the Watch Dog feature.
Permitted
Values
0-Disabled
1-Enabled, the phone will reboot automatically when the system crashed.
Default
1
Web UI
Settings > Preference > Watch Dog
Network Diagnostics
You can use ping and traceroute diagnostics for troubleshooting network connectivity via the web user interface or
phone user interface.
You can also enable the phone to detect the reachability of the connected wired or wireless network via auto pro-
visioning. The phone can display an icon warning (for T42S/T42U/T41S IP phone, prompt a message) on the
phone screen when the network is unreachable. You can set the time interval for network reachability detection.
Topics
Ping and Traceroute Diagnostics
Network Reachability Detection Configuration
Ping and Traceroute Diagnostics
Procedure
1. From the web user interface, click Network > Diagnostics.
2. Select Ping or Traceroute from the Command drop-down menu.
3. Enter an IP address or a URL (for example, 10.200.108.48) in the IP Address field.
4. Click Start to start a ping.
You can also diagnose network via the phone user interface at the path: Menu > Features > Diagnostics > Net-
work > Ping or Menu > Features > Diagnostics > Network > Trace Route.
To Next Page
Loading...
Need help?
General