Yealink T26 User Manual

Config Encrypt Key
Input the Encrypt Key, if the configuration file is
encrypted.
Common Config
Encrypt Key
Input the Common Encrypt Key, if the Common
Configuration file is encrypted
Save Autoprovision
Information
Save the username and password authentication
message of http/https/ftp and input ID message in the
phone until the URL in the server changes
DHCP Option
Setting
DHCP Option
Setting
Specify DHCP Option. DHCP option supports DHCP
custom option and DHCP option 66 and DHCP option
43 to obtain the parameters. You could choose one
method among them，the default is DHCP option
disable.
Custom DHCP
Option
A valid Custom DHCP Option is from 128 to 254. The
Custom DHCP Option must be in accordance with the
one defined in the DHCP server.
Plug and Play
Enable PnP
Enable PnP by selecting it, than the phone will send
SIP SUBSCRIBE messages to a multicast address
when it boots up. Any SIP server understanding that
message will reply with a SIP NOTIFY message
containing the Auto Provisioning Server URL where
the phones can request their configuration.
PnP Server
Specify the PnP Server
PnP Port
Specify the PnP Server
PnP Transport
Specify the PnP Transfer protocol
PnP Interval
Specify the Interval time, unit is hour
Phone Flash
Server Address
Set FTP/TFTP/HTTP/HTTPS server IP address for
auto update. The address can be IP address or Domain
name with subdirectory.
Config File Name
Set configuration file‟s name which need to update.
System will use MAC as config file name if config file
name keep blank. For example, 000102030405.。
Protocol Type
Specify the Protocol type FTP、TFTP or HTTP.
Update Interval
Specify update interval time, unit is hour.
Update Mode
Different update modes:
1. Disable: means no update
2. Update after reboot: means update after reboot.
3. Update at time interval: means periodic update.

Yealink T26 Specifications

General

Brand	Yealink
Model	T26
Category	IP Phone
Language	English