Yealink T26 User Manual

DNS Domain
Set DNS domain postfix. When the domain which
you input cannot be parsed, phone will automatically
add this domain to the end of the domain which you
input before and parse it again.
Primary DNS
Input your primary DNS server address.
Sencondary DNS
Input your standby DNS server address.
If you uses PPPoE mode， you need to make the above setting.
PPPoE Server
It will be provided by ISP.
User
Input your ADSL account.
Password
Input your ADSL password.
Notice:
1) Click “Apply” button after finished your setting, IP Phone will save the
setting automatically and new setting will take effect.
2) If you modify the IP address, the web will not response by the old IP
address. Your need input new IP address in the address column to logon in
the phone.
3) If networks ID which is DHCP server distributed is same as network ID
which is used by LAN of system, system will use the DHCP IP to set WAN,
and modify LAN‟s networks ID (for example, system will change LAN IP
from 192.168.10.1 to 192.168.11.1) when system uses DHCP client to get IP
in startup; If system uses DHCP client to get IP in running status and
network ID is also same as LAN‟s, system will refuse to accept the IP to
configure WAN. So WAN‟s active IP will be 0.0.0.0
LAN Config
LAN Config

Yealink T26 Specifications

General

Brand	Yealink
Model	T26
Category	IP Phone
Language	English