EasyManuals Logo

Yealink T42G Quick Start Guide

Yealink T42G
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Basic Call Features
Call Mute and Un-mute
Press to mute the microphone during a call.
Press again to un-mute the call.
4
Call Hold and Resume
To place a call on hold:
1. Press the Hold soft key during an active call. The first line key LED slowly flashes green.
Note: You can reject an incoming call by pressing
More
->
Reject
.
Note: During a call, you can alternate between the headset, hands-free speakerphone and handset modes by
pressing the HEADSET key, the Speakerphone key or by picking up the handset. Headset mode requires
a connected headset.
Placing a Call
Using the handset:
1. Pick up the handset.
2. Enter the number, and then press the Call soft key.
Using the speakerphone:
1. With the handset on-hook, press
.
2. Enter the number, and then press the Call soft key.
Answering a Call
If you are using the handset, pick up the handset.
If you are using the headset, press .
If you are using the speakerphone, press .
Ending a Call
If you are using the handset, hang up the handset or press the EndCall soft key.
If you are using the speakerphone, press or press the EndCall soft key.
If you are using the headset, press the EndCall soft key.
Redial
Press when the phone is idle to dial out the last dialed number.
2. Enter the number, and then press the
Call
soft key.
Using the headset:
1. With the headset connected, press to activate the headset mode.
To resume the call, do one of the following:
If there is more than one call on hold, press or to select the call you want to resume, and then
press the Resume soft key .
If there is only one call on hold, press the Resume soft key.

Other manuals for Yealink T42G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink T42G and is the answer not in the manual?

Yealink T42G Specifications

General IconGeneral
Power requirements100-240V, DC 5V
Power over Ethernet (PoE)Yes
Touchscreen-
Display diagonal2.7 \
Display resolution192 x 64 pixels
Lines quantity- lines
Phonebook capacity1000 entries
Number of VoIP accounts3
Voice codecsG.711, G.723, G.729A, G.729B
BluetoothNo
RJ-9 ports quantity2
Ethernet LAN (RJ-45) ports1
Storage temperature (T-T)-10 - 50 °C
Operating relative humidity (H-H)10 - 95 %
MountingDesk/Wall
Handset typeWired handset
Product typeIP Phone
Product colorBlack, Grey
Number of handles included1 pc(s)
Weight and Dimensions IconWeight and Dimensions
Depth175 mm
Width212 mm
Height189 mm

Related product manuals