4. All major provisioning settings are pre-populated. If your PBX has multiple network cards, select to
which network this IP phone is connected.
5. Click “OK”. The phone will configure automatically and will reboot to finalize the setup.
Remote phones: Provision via RPS server
1. Take note of the phone’s MAC address, usually written at the back.
2. Navigate to the 3CX Management Console ⇒ “Phones” and press “+ Add Phone”.
3. From the dropdown list select the extension to which this phone must be assigned.
4. In the next dialog select the Vendor/Model of the phone and enter the device’s MAC address.
To Next Page
Loading...
