Yealink T48

Answering calls
When you receive an incoming call,
the phone rings and the screen
displays the caller’s information.
You can choose to answer the
incoming call in the following ways:
• By picking up the handset.
• By pressing the Speakerphone
key.
• By pressing the Headset key.
• By pressing Answer, or the line
key that has the flashing green
LED indicator.
Transferring calls
You can transfer a call to another
person in one of the three ways.
• Blind transfer: sends a call
directly to another person
without consulting them.
• Semi-attended transfer:
sends the call while the target
phone is ringing.
• Attended transfer: sends a
call after you’ve spoken to the
person first.
To make a blind transfer
• Press the Tran soft key during a call.
• Enter the number you want to
transfer the call to.
• Press the Tran soft key to
complete the transfer.
The call will then be connected to the
number you’re transferring it to.
To make a semi-attended
transfer
• Press the Tran soft key during a call.
• Then either:
• Enter the number you want to
transfer the call to.
• Press the Directory soft key to
find the number of directory or
History.
• Press or to dial out.
• Press the Tran soft key to
complete the transfer when you
hear the target phone ringing.
To perform an attended transfer
• Press the Tran soft key during a call.
• Either enter the number you want
to transfer the call to, or press
the Directory soft key to find the
number from directory or history.
• Press
or to dial out.
• After the person answers the
call, press the Tran soft key to
complete the transfer.
• If you’re using a handset, complete
the transfer by hanging it up. You
can cancel a transfer before the
call’s connected by pressing the
Cancel soft key.
Ending calls
There are three ways to end a call:
• If you’re using the handset, press
the Cancel soft key or hang up the
handset.
• If you’re using the headset, press
the Cancel soft key.
• If you’re using the speakerphone,
press or the Cancel soft key.
Conference calls
To set up a conference call:
• Dial the first person then press the
Conf soft key; they’ll be put on hold.
• Dial the number of the next person
you want to join the call and press
, , or the Send soft key.
• When they answer, press the Conf
soft key again.
• Repeat the process until everyone
has joined the conference call.
During your conference call, you can:
• Press the Hold soft key to place
the conference call on hold.
• Press the Split soft key to split the
call into two individual calls.
• Press the New Call soft key to
make a new call.
• Press the Back soft key to return to
the previous screen.
• Press the Mute key to mute
the call.
• Press the Cancel soft key to end
the call.
13