1. Introduction
1.1. Purpose of this Document
This guide is to show you how to install and use your Yealink T48G phone which
you will use in conjunction with the Nimbus UC portal www.nimbusuc.com,
therefore the functionality and features described are an appropriate subset of
those available. Full details of the phone’s capabilities can be found in the Yealink
SIP-T48G which can be obtained from the Yealink web site. However, always use
the facilities and features offered by the portal website in configuring your phone
in preference to any local capabilities.
1.2. Related Documents
The Nimbus UC Setup and User Guide provides guidance for the ordinary user on
the facilities and features of your phone system. It should be used in conjunction
with this guide.
The Nimbus UC System Administrator’s Guide provides instruction for the
Company Administrator in setting up the system and configuring the features and
functionality available to each user.
For Gold product Administrators there is an additional Nimbus UC Gold
Subscriber’s Guide for the Auto Attendant, Call Recording and Call Queueing
Capabilities.
These guides can be downloaded from the Support Menu on the portal website or
accessed via the Help menu.
1.3. Yealink Phone On-line Customisation
Certain features of the Yealink phone operation can be customised via a web
browser. These are restricted to setting up the appropriate network connections,
changing the ring tones and security password and, if desired creating a local
phone directory, although this is discouraged as your portal website is the natural
place for personal and company phone directories. All other features and settings
relevant to phone usage are handled by your portal website.
To Access the Yealink web user interface tap the Menu soft key on your phone
followed by selecting the Status option. This will display your phone details. Note
down the IP address and enter that into your web browser. This will bring up the
Yealink web user interface requesting your Username and Password to login. The
default for both is ‘User’. These may be changed via the Security tab.
The Network tab allows you to specify what sort of network connection you wish
to make IP4 or IP6, DHCP or Static IP.
To Next Page
Loading...
Need help?
General
