4
To connect to AC power:
I. take the Ethernet cable and plug it into your base station
II. plug the other end of the Ethernet cable into your hub or switch
III. then connect the power adaptor to your base station.
Your base station can use AC power or power over Ethernet.
Ask your IT team what’s best for you.
Step one:
Get your base station working
2. Set up your phone in three steps
To start using your phone, you should:
1. get your base station working
2. power up your USB charger
3. charge your phone.
To connect to power over Ethernet:
I. check your hub or switch is up to IEEE 802.3af standards
II. take the Ethernet cable and plug it into your base station
III. plug the other end of the Ethernet cable into your hub or switch.
To Next Page
Loading...
