5
You can set up your base station to stand by itself. To do this:
I. connect the cables
II. snap the stand into place at the back of the base station.
Or keep it out the way by mounting it on the wall:
I. get two screws
II. drive them into your wall, 59mm apart
III. then hang the base station on the screws.
Step two:
Power up your USB charger
Think about where you’re most likely to take calls in your office. Plug your charger
into the nearest outlet. To do this:
I. set the USB charger on a desk or mount it on the wall using two screws
– driven into the wall 36mm apart
To Next Page
Loading...
