NeoGate User Manual
www.yeastar.com 30
Figure 3-23
3.6.7 Reset and Reboot
·Reboot System
Warning: Rebooting the system will terminate all active calls!
·Reset to Factory Defaults
Warning: A factory reset will erase all configuration data on the system.
Please do not turn off the system until the RUN light begins blinking. Any power
interruption during this time could cause damage to the system.
Figure 3-24
3.6.8 Firmware Update
Upgrading of the firmware is possible through the Administrator web interface
using a TFTP Server or an HTTP URL.
Enter your TFTP Server IP address and firmware file location, then click start to
To Next Page
Loading...
Need help?
General
