TA1600/2400/3200 User Manual
35/87
Table 5-7 Description of SIP Advanced Settings
Where to get the caller ID in SIP packet.
Where to get the DID in SIP packet.
It is set when the telecom provider needs. Usually
it is not needed.
Whether to send Remote-Party-ID on SIP header
or not. Default: no.
Whether to allow anonymous registration
extension or not. Default: no. It’s recommended
that it is disabled for security reason.
Enable pedantic parameter. Default: no.
If enabled, when TA FXS Gateway rejects
“Register” or “Invite” packets, TA FXS Gateway
always respond the packets using “SIP404 NOT
FOUND”. It’s recommended that it is enabled for
security reason.
If set to yes, the response to an OPTIONS is
always 200OK.
Enable session-timer mode, default: yes. If you find
the call is cut off every 15 minutes every time,
please disable this.
The min refresh interval, which mustn't be shorter
than 90s.
Choose the session-refresher, the default is Uas.
IAX Settings
IAX is the Internal Asterisk Exchange protocol, you can connect to TA FXS Gateway
or register IAX trunk to another IAX server. It’s supported by the asterisk-based