2-3
IM DL350-17EN
USB Interface
2
Switching between Remote and Local Modes
Switching from Local to Remote Mode
The instrument switches to remote mode when it is in local mode and it receives a
:COMMunicate:REMote ON
command from the PC.
In Remote Mode
• “Remote” appears in the top center of the screen.
• Tapping the touch panel or pressing a front panel key displays the following conrmation
message for releasing remote mode. All touch panel and key operations outside this message
will be invalid.
• Settings entered in local mode are retained even when the instrument switches to remote mode.
Switching from Remote to Local Mode
1.
In remote mode, tap the touch panel or press a front panel key. A conrmationmessage for
releasing remote mode appears.
* However, this does not work if the instrument has received a
:COMMunicate:LOCKout ON
command
from the PC.
2.
Tap OK. Remote control using communication commands is disabled, and the instrument
switches to local mode.
The instrument switches to local mode when it receives a
:COMMunicate:REMote OFF
command
from the PC, regardless of the local lockout state.
In Local Mode
• The REMOTE indicator in the top center of the screen disappears.
• Key and touch panel operations are enabled.
• Settings entered in remote mode are retained even when the instrument switches to local mode.
Note
You cannot use the USB interface simultaneously with the Ethernet interface.
2.2 USB Interface Features and Specifications
To Next Page
Loading...
Need help?
General
