EasyManuals Logo

YOKOGAWA GX60 User Manual

YOKOGAWA GX60
590 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #544 background imageLoading...
Page #544 background image
11
All Rights Reserved. Copyright © 2012, Yokogawa Electric Corporation
GS 04L51B01-01EN
Nov. 10, 2015-00
• Conguringscreens:Screencreationsoftware
CreationusingDXA170DAQStudio(GXdoes
nothaveacreationfunction)
• Saving/loadingscreendata:
Aspeciedscreenorallthescreensis/are
loadedfromanexternalstoragemediumtothe
internalmemory,oraspeciedscreenorallthe
screens in the internal memory is/are saved on
anexternalstoragemedium.
VGAVIDEOOUTPUT(/D5)(OnlyforGX20)
• Externaldisplay:
Resolution:800×600dots(VGA)
Connector:15-pinD-Sub(female)
EtheNet/IPCOMMUNICATION(PLC
communicationprotocol)(/E1)
CanbejoinedtoanEthernet/IPnetworkasan
adapter (or a server).
• LoadingdatafromtheI/Ochannelorcalculation
channel (/MT)
I/Ochannel:
GX10: 100, GX20-1: 100, GX20-2: 500
Calculation channel:
GX10: 50, GX20-1: 100, GX20-2: 100
• Loadingandwritingdatafrom/tothe
communication channel (/MC)
Communication channel:
GX10: 50, GX20-1: 300, GX20-2: 500
WTCOMMUNICATION(/E2)
CollectsdatabyconnectingtoWTequipment
manufacturedbyYokogawaMeters&Instruments
Corp. via Ethernet communication.
• Supportedmodels:WT1800,WT500,and
WT300
• Numberofconnectableunits:
GX10: 8
GX20: 16
• Communicationcycle:500ms/1s/2s/5s/10s/20
s/30 s
• Typesofdatathatcanbeobtained:Voltage,
current,power,powerfactor,phase,electrical
energy,high-frequencywave,etc.
• Numberofdataallocations
GX20300
GX1050
FAILOUTPUT(/FL)
• Contact:Ccontact,1point
• FAILoutput:
The relay contact output on the rear panel
indicatestheoccurrenceofCPUfailure.
Relay operation: Energized during normal
operationandde-energizedonCPUfailure.
• Statusoutput:Therelaycontact,whichisde-
energized in normal output state, is energized
upontheoccurrenceofamemory/mediaerror,
measurement error, communication error,
recording stop, or alarm.
• Ratedpowersupplyvoltage:24VDCor250V
ACorless
• Ratedloadcurrent:3A(DC)/3A(AC),resistance
load
• Min.loadcurrent:100mA
• Recommendedreplacementperiodsofcontact:
Electrical:30,000moreON-OFFoperations,
Mechanical:5,000,000moreON-OFFoperations
LogSCALE(/LG)
Alogarithmicvoltagethathasbeenconvertedfrom
a physical value is applied to the GX, and then the
GX’sLogscale(logarithmicscale)isusedtodisplay
and record the physical value.
• Inputtype:Loginput(logarithmicinput),Pseudo
loginput:Aninputthatsupportspseudo
logs,Loglinearinput:Inputthatislinearona
logarithmic scale.
• Range:20mV/60mV/200mV/1V/2V/6V/20V/50V
• Scalablerange:
• Loginput:
1.00E-15to1.00E+15(15decade
maximum)
Scale_L<Scale_U
Ifthelowerlimitmantissais1.00,the
differencebetweentheexponentsmustbe
1 or more.
Ifthelowerlimitmantissaisavalueother
than1.00,thedifferencebetweenthe
exponentsmustbe2ormore.
• PseudoLogInput/Loglinearinput
1.00E-15to1.00E+15(15decade
maximum)
The higher limit mantissa is the same as
the lower limit mantissa).
Ifthelowerlimitmantissais1.00,thevalue
mustbebetween1.00E–15and1.00E+15,
thedifferencebetweentheexponentsmust
be1ormore,andthemaximumdecadesis
15.
Ifthelowerlimitmantissaisavalueother
than 1.00, the value must be between
1.01E–15and9.99E+14,thedifference
betweentheexponentsmustbe1ormore
andthemaximumdecadesis15.
• Alarmtype:Highlimit,lowlimit,delayhighlimit,
and delay low limit
• Alarmsettingrange:Therangeconvertedinto
theLOGscalecorrespondingto-5%to105%of
the span width.
• Alarmhysteresis:Fixedto0
• Greenbandsettingrange:Thelowerlimittothe
upperlimitofthescale.However,thelowerlimit
ofthedisplaypositionmustbesmallerthanthe
upper limit.
• Positionofthedecimalpoint:1to2
• Misc:Nonlinearinputispossiblebycorrecting
the input value

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the YOKOGAWA GX60 and is the answer not in the manual?

YOKOGAWA GX60 Specifications

General IconGeneral
BrandYOKOGAWA
ModelGX60
CategoryVoice Recorder
LanguageEnglish

Related product manuals