xvi
IM WT310E-02EN
Workflow
The figure below is provided to familiarize the first-time user with the workflow of operation. For a
description of an item, see the relevant section or chapter. In addition to the sections and chapters that
are referenced in the figure below, this manual also contains safety precautions for handling and wiring
the instrument. Be sure to observe the precautions.
Getting Started Guide
Section 2.2
Sections 2.3 and 2.4
Section 2.8
Sections 2.9 to 2.11
Installation and Circuit Wiring
Install this instrument.
Connect the power supply, and turn the power on.
Select the measurement method.
Wire the circuit under measurement.
Getting Started Guide
Sections 3.1 and 3.2
Section 3.3
Common Operations
Perform key operations.
Initialize settings.
User’s Manual
Chapter 2
Set the Measurement Conditions
Measurement conditions
User’s Manual
Section 4.1
Section 4.2
Section 4.3
Section 4.4
Section 4.5
Chapter 5
Chapter 6
Display Measured/Computed Results
Voltage, current, and active power
Apparent power, reactive power, and power factor
Phase angle and frequency
Peak value
Crest factor, etc.
Integrated power (watt hour)
Harmonic measurement
User’s Manual
Chapter 7
Section 8.4 and chapter 5 of the
Getting Started Guide
Communication Interface
User’s Manual
Acquire Data
Store data to internal memory.
Transmit data using D/A output (option).
Transmit data through the USB, GP-IB,
RS-232, or Ethernet interface.
Read the precautions in sections 2.5 and 2.7 thoroughly before connecting the wires.
Also, if necessary, assemble the input terminal adapter that connects to the voltage
input terminal (see section 2.6) before connecting the wires.
To Next Page
Loading...
Need help?
General
