-44-
2. Power-on and Power-offz
that the batteries should be taken out after turned off the speedlite through this button.
the speedlite will automatically shutdown, indicating it need to change new batteries.
You can press the [PILOT] button to test whether the speedlite works normally.
After use, turn off the speedlite by long pressing the [ON/OFF] button for about 2 seconds.
3. ETTL Mode
reflected back from the object so as to automatically adjust the flash output,
then the subject and background get balanced exposure.Supports exposure
light,Canon camera menu access function and etc.
of the flash, the flash exposure compensation range is－5EV～＋5EV,in 1/3
stop precision.
4. M Mode
In M mode, you can set flash brightness according to your preferences, and
The power of the speedlite can be turned on or turned off by long pressing the [ON/OFF] button. It is recommend
After turning on the power of the speedlite, the [PILOT] indicator light is red, which indicates the speedlite is available.
If in low battery, the charging is not completed within 20 seconds, the screen will display the low battery icon,
In this mode, the metering system of this camera will detect flash illumination
compensation,exposure bracketing, rear-curtain sync,exposure lock,modeling
You can set exposure compensation by pressing the[Left] and [Right] buttons
adjust flash brightness by the [Left], [Right], [Up] and [Down] buttons. Adjustment
range of flash brightness is 1/128~1/1, and the brightness can be divided into
8 grades,each has maximum three grades for fine adjustment, and takes
To Next Page
Loading...
Need help?
General
