-48-
state,and then select the option numbered 01 with the [Up] and [Down] buttons,set the state to be “SL EP - -”
with the [Left] and [Right] buttons, means the“Automatic power off” function is closed, and when the state is “SL
EP on”, means the “Automatic power off” function is enabled.
Power saving modes set by advanced option are as following:
Fn NO.
Scope of
Application
Options
Power Saving Mode
All modes
Power saving mode is turned off
Power saving mode is turned on
Power automatic off the slave unit is 10 minutes
Power automatic off the slave unit is 60 minutes
Slave auto power off cancel within 1 hours
Slave auto power off cancel within 8 hours
Sleep after idle time of 3minutes/5 minutes/30 minutes/1 hour/2
hours/3hours/5hours.After it enters the sleep state, it powers off
automatically after keeps the same idle time.
Set-top power saving mode off
– –
on
10
60
1H
8H
3/5/10/30/1H/
2H/3H/4H/5H
– –
Sc/Sn/S1/S2
Sc/Sn/S1/S2
Set-top flash
01
SL EP
10
SL Sd
11
SL OF
E1
SE OF
In dormant state,the screen will display“SE”,the flash can be waken by pressing any button.
10.Overheating Protection
If the speedlite is used too frequently, the overheating protection function will be triggered; the OVERHEATING
indicatorwill be displayed on LCD panel. And the speedlite will be locked. In such case, please wait for about 3
To Next Page
Loading...
Need help?
General
