-63-
4. You must set the FEB every time?
You can access FEB setting through camera menu or lock FEB setting through Fn advanced option setting to
03. It is ok to set the “FEB auto cancel” disabled.
5. Overexposure of photo
Please check whether the FEB sequence is set as “－→0→＋”. You can change the FEB sequence to “0→－
→＋” through menu accessable or advanced setting. Or enable the FEB auto cancel.
6. Vignetting appears in photos or only part of the subject is illuminated?
range of the flash. The product’s zooming range is 24~105mm of the medium format system.
7. The state of YN565EX II is abnormal.
Please try to turn off the power supply YN565EX II and camera. After YN565EX II is installed on the hot shoe
of camera, turn on the power supply again. If it is still unusual, please replace the batteries.
avoid that FEB will cancel automatically when completing three shooting tasks. The number of setting option is
Please check the current coverage of focal length and make sure if the lens focal length exceeds the coverage
To Next Page
Loading...
