York OPTIVIEW YIA D - Control Center Setup; Figure 20 - Sample Printout (Operating Data)

FORM 155.21-O1 (615)
67
JOHNSON CONTROLS
3
Control Center Setup
Printer Setup
Access Level Required: OPERATOR
Using the COMMS Screen, the Control Center must be
congured to transmit data in the same format as the
Printer is congured to receive the data. The following
values must be entered.
• Baud Rate - Set as desired. Value selected must be
the same as Printer conguration above.
• Data Bits - 8
• Parity - None
• Stop Bits - 1
YORK A JOHNSON CONTROLS COMPANY
UNIT MODEL < > SERIAL NUMBER < >
<DATE>, <HOUR>
TOTAL OPERATING HOURS < > [HOURS]
LATEST RUN TIME < > [DAYS, HOURS, MINUTES]
SOFTWARE VERSION < >
- O P E R A T I N G D A T A R E P O R T -
SYSTEM STATUS < >
CONTROL STATUS < >
SYSTEM DETAILS < >, < >, < >
RETURNING CHILLED LIQUID TEMPERATURE............ < >
REFRIGERANT TEMPERATURE........................................ < >
REFRIGERANT TEMPERATURE........................................ < >
ADC LINE TEMPERATURE................................................. < >
STRONG SOLUTION TEMPERATURE............................... < >
STRONG SOLUTION CONCENTRATION.......................... < >
SOLUTION TEMPERATURE LEAVING STS...................... < >
REFRIGERANT FROM CONDENSER TEMEPERATURE.... < >
MIN SOLUTION TEMP TO CRYSTALLIZE........................ < >
RETURNING COOLING LIQUID TEMPERATURE........... < >
LEAVING COOLING LIQUID TEMPERATURE................. < >
ENTERING HOT WATER TEMPERATURE......................... < >
STEAM TEMPERATURE IN................................................. < >
STEAM PRESSURE............................................................... < >
MAX ALLOWED LOADING................................................ < >
CONTROL VALVE POSITION [%]....................................... < >
GENERATOR SHELL PRESSURE........................................ < >
LEAVING CHILLED LIQUID SETPOINT............................ < >
REMOTE TEMP SETPOINT RANGE................................... < >
REMOTE LOAD LIMIT......................................................... < >
AUTOPURGE 7 DAY COUNTER......................................... < >
AUTOPURGE TOTAL COUNTER........................................ < >
PURGE TANK PRESSURE.................................................... < >
PURGE PUMP PRESSURE.................................................... < >
PULLDOWN SETPOINT TIME............................................. < >
PULLDOWN SETPOINT START.......................................... < >
PULLDOWN SETPOINT STOP............................................. < >
CHILLED LIQUID PUMP RUN CONTACTS (ON/OFF)..... < >
CONDENSER LIQUID PUMP RUN CONTACTS (ON/OFF)... < >
CHILLED LIQUID FLOW SWITCH (OPEN/CLOSE)......... < >
CONDENSER LIQUID FLOW SWITCH (OPEN/CLOSE).. < >
REFRIGERANT PUMP (ON/OFF)........................................ < >
SOLUTION PUMP (ON/OFF)................................................ < >
ABSORBER PUMP (ON/OFF) -IF FRANKLIN-.................. < >
GENERATOR PUMP (ON/OFF) -IF FRANKLIN-................ < >
REFRIGERANT LEVEL SWITCH 1F (OPEN/CLOSE)....... < >
REFRIGERANT LEVEL SWITCH 3F (OPEN/CLOSE)....... < >
STABILIZER REFRIGERANT SOLENOID VALVE 2SOL
(OPEN/CLOSE)....................................................................... < >
REFRIGERANT LEVEL SOLENOID VALVE 3SOL
(OPEN/CLOSE)....................................................................... < >
MOTOR COOLANT SOLENOID VALVE 4SOL
(OPEN/CLOSE) -IF FRANKILN-.......................................... < >
REV. 1.0 2008
FIGURE 20 – SAMPLE PRINTOUT
(OPERATING DATA)