JOHNSON CONTROLS
9
SECTION 1 - SHIPPING
FORM 160.69-N3
ISSUE DATE: 10/30/2015
1
CHILLER DATA PLATE
A unit data plate is mounted on the control center as-
sembly of each unit, giving unit model number; design
working pressure; water passes; refrigerant charge; se-
rial numbers; and motor power characteristics and con-
nection diagrams.
Additional information may be found on the motor
data plates. This information should be included when
contacting the factory on any problem relating to the
motor.
RIGGING
The complete standard chiller is shipped without skids.
(When optional skids are used it may be necessary to
remove the skids so riggers skates can be used under
the unit end sheets to reduce overall height.)
Each unit has four (4) lifting holes (two in each end)
in the end sheets which should be used to lift the unit.
Care should be taken at all times during rigging and
handling of the chiller to avoid damage to the unit and
its external connections. Lift only using holes shown in
Figure 1 on page 10.
Never lift the unit with slings around mo-
tor/compressor assemblies or by means
of eyebolts in the tapped holes of the
compressor motor assemblies. Do not
turn a unit on its side for rigging. Do not
rig vertically.
The rigging and operating weights and overall dimen-
sions are given on pages 8 thru 10 as a guide in deter-
mining the clearances required for rigging. Add 6" (15
cm) to overall height for optional skidded unit.
The lengthwise rigging bar should be longer than the
chiller tube length, and must have counter or clevis ad-
justments to allow for center of gravity adjustments.
Chain spreaders should be used to avoid contact with
drive motors or other chiller parts.
To Next Page
Loading...
