JOHNSON CONTROLS
26
FORM 160.81-O1 (1020)
ISSUE DATE 10/05/2020
SECTION 2 - OPTIVIEW™ CONTROL CENTER
Optiview Control Center
includes offset pressure derived from auto-zeroing dur-
ing the Start Sequence Initiated. If either of the trans-
ducers used to calculate this differential is out of range,
the display field will show XX.X.
% Full Load Amps
This displays the percentage of full load amps utilized
by the system.
Current Limit
Displays the current limit value in use. This value could
come from a 0 to 20mA or 4-20 mA, 0 to 10VDC or 2
to 10VDC input in Analog Remote mode, PWM signal
in Digital Remote mode, MicroGateway interface in
ISN mode, or a locally programmed value.
Programmable
None
Navigation
Home
Access Level Required: VIEW
Causes an instant return to the HOME screen.
To Next Page
Loading...
