Need help?Do you have a question about the York YPC and is the answer not in the manual?
Details the two-stage absorption refrigeration cycle using water and lithium-bromide.
Explains custom-matched selections and provides IPLV analysis based on ARI 560-2000.
Explains automatic variation of steam flow to maintain setpoint for loads 20-100%.
Describes manual and remote limiting of steam input from 20% to 100% of capacity.
Details warning annunciations and limited heat input for potential shutdown conditions.
Lists conditions causing unit shutdown and required restart procedures.
Explains how the panel monitors first-stage generator concentration to prevent unsafe operation.
Explains the automatic removal of noncondensible vapors using an eductor and pump.
Details the microprocessor-based control center for automated operation and energy efficiency.
Explains safety logic for unit protection and annunciation of shutdown causes.
Details flow rate, temperature ranges, and quality requirements for water circuits.
Details the chilled water circuit, including flow switch and strainer requirements.
Covers condenser water circuit flow proving and temperature control recommendations.
Explains the chiller's on/off cycling logic based on leaving chilled water temperature.
General information on steam requirements, pressure, and temperature limits.
Details steam piping requirements, including separators, strainers, and control valve placement.
Specifies materials and thicknesses for generator, drain cooler, and other heat exchanger tubes.
Details hermetically sealed pumps for solution and refrigerant, including service intervals.
Details the steam control valve, actuator, and communication signal.
Overview of the factory-mounted control system with Power Panel and MicroComputer Control Center.
Details the control center panel with alphanumeric display and sensors.
Lists conditions that trigger warning messages and potential heat input limitation.
Explains automatic control of steam flow rate for cooling loads.
Details conditions causing unit shutdown and the requirement for manual restart.
To Next Page
General
