FORM 160.81-O1 (1020)
ISSUE DATE 10/05/2020
51
JOHNSON CONTROLS
SECTION 2 - OPTIVIEW™ CONTROL CENTER
2
SETUP SCREEN
Overview
This screen is the top level of the general configura-
tion parameters. It allows programming of the time and
date, along with specifications as to how the time will
be displayed (12 or 24 hour format). In addition, the
chiller configuration, as determined by the state of the
Microboard Program Jumpers and Program Switches
is displayed. A qualified Service Technician, following
instructions in OptiView Control Center Service In-
structions (Form 160.81-M1, establishes this configu-
ration per the desired operation. This screen also serves
as a gateway to more sub-screens for defining general
system parameters.
031-01730-000 Microboard
Chilled Liquid Pump Operation
Displays Standard or Enhanced
Refrigerant Selection
Displays R134a
Anti-Recycle
Displays Disabled or Enabled
Power Failure Restart
Displays Manual or Automatic
Liquid Type
Displays Water or Brine
031-02430-000 Microboard
Refrigerant Selection
Displays R134a
Liquid Type
Displays Water or Brine
Programmable
Set Date
Access Level Required: OPERATOR
Allows the user to specify the present date. This value
is critical to logging system shutdowns accurately and
for utilizing the scheduling capabilities. When prompt-
ed to enter a date value, the user must enter the day,
month, and four-digit year (using leading zeroes as
necessary). If within range, the value will be accepted.
If out of range, the user is prompted for the information
again. At this point the user may retry the date entry, or
cancel the programming attempt.
Set Time
Access Level Required: OPERATOR
Allows the user to specify the present time. This value
is critical to logging system shutdowns accurately and
for utilizing the scheduling capabilities. When prompt-
ed to enter a time value, the user must enter the hour
and minute desired (using leading zeroes as necessary).
FIGURE 17 - SETUP SCREEN
LD09721
To Next Page
Loading...
