York YS - OptiView Control Center Screens (Part 4); Schedule, User, and Communication Settings; Sales Order, Operations, and History Screens

10 JOHNSON CONTROLS
OptiView Control Center - continued
The following six subscreens can be accessed from
the SETUP screen:
The SCHEDULE screen contains more programmable
values than a normal display screen. Each programmable
value is not linked to a specic button; instead, the select
key is used to enable the cursor arrows and check key to
program the Start/Stop times for any day of the week up
to 6 weeks in advance. The user has the ability to dene
a standard set of Start/Stop times that are utilized every
week or specify exceptions to create a special week.
Programmable:
• Exception Start/Stop Times
• Schedule (Enable/Disable)
• Repeat Sunday Schedule
• Standard Week Start/Stop Times
• Reset All Exception Days
• Select
• Print
The USER screen allows denition of the language for the
chiller to display and denes the unit of measure.
Programmable:
• System Language
• English/Metric Units
The COMMS screen allows the user to dene commu-
nications parameters.
Programmable:
• Chiller ID
• COM 2 Baud Rate
• COM 2 Data Bit(s)
• COM 2 Parity Bit(s)
• COM 2 Stop Bit(s)
• Printer Baud Rate
• Printer Data Bit(s)
• Printer Parity Bit(s)
• Printer Stop Bit(s)
The PRINTER screen permits the user to dene com-
munications Parameters for the Printer.
Display Only
• Time Remaining Until Next Print
Programmable
• Log Start Time
• Output Interval
• Automatic Printer Logging (Enabled/Disabled)
• Print Type
• Print Report
• Print All Histories
The SALES ORDER screen allows denition of the order
parameters. Note: This information is loaded at the factory
or by the installation service technician.
Display Only
• Model Number
• Panel Serial Number
• Chiller Serial Number
• YORK Order Number
• System Information
• Condenser and Evaporator Design Load Information
• Nameplate Information
The OPERATIONS screen permits denition of param-
eters pertaining to operation of the chiller. What is dened
is whether the control of the chiller will be Local, Digital Re-
mote, Analog Remote, Modem Remote or ISN Remote.
Programmable
• Control Source
The HISTORY screen allows the user to browse through
the last ten faults; either safety or cycling shutdowns with
the conditions, while the chiller is running or stopped.
The faults are color coded for ease in determining
the severity at a glance, recording the date, time and
description. (See Display Messages for Color Code
meanings.)
Display Only
• Last Normal Shutdown
• Last Fault While Running
• Last Ten Faults
Programmable:
• Print History
• Print All Histories
By pressing the VIEW DETAILS key you will move to the
HISTORY DETAILS screen. From these screens you
are able to see an on-screen printout of all the system
parameters at the time of the selected shutdown.