Maintenance
2928
Alarm system
When the determined blood pressure is outside
the rated range, there is a visual alarm signal on
the display screen. Please refer to below table
for details.
the user feels uncomfortable, please consult the
doctor as soon as possible.
Note: If the alarm indication cannot be solved or
need to verify the functionality of the alarm system,
please consult the manufacturer.
Note: If the alarm indication cannot be solved and
When the above alarm indication shows, please measure
consult the doctor.
again or
①When SYS display area shows it indicates
the measurement result of diastolic pressure is below
40mmHg.
" ",
②When DIA display area show it indicates
the measurement result of diastolic pressure is below
20mmHg.
" ",
①When SYS display area shows it indicates
the measurement result of systolic pressure exceeds
260mmHg.
" ",
②When DIA display area shows it indicates the
measurement result of diastolic pressure exceeds
210mmHg.
" ",
Alarm
indication
Display contents and causes
①
②
①
②
Please store the monitor and accessories properly
after use.
Do not place the monitor and accessories in high
temperature, moisture, dust, or exposure to
sunshine.
The cuff contains an airbag inside, please care in
applications, do not fold, pull or twist it.
Warning: Do not disassemble or repair the device
authorization without or modify the device
without authorization.
Do not service or maintain while the device is in
use.
Using soft dry cloth or soft cloth stained with little
water to clean the device in the case of single
people use it, but do not let the water flow into the
monitor and cuff.
Using soft cloth stained with 75% ethanol to clean
the device in the case of many people use it, but do
not let the ethanol flow into the monitor and cuff.
Don't clean the device when it is connected to the
AC mains supply.
Manufacture will make available on request circuit
diagrams, component part lists, descriptions,
calibration instructions, or other information that
will assist service person to repair those parts of
the device that are designated by the manufacture
as repairable by service person.
Degraded sensors can degrade performance.
Please observe the following items to protect the
device and ensure the accuracy of measurement.
We advice to calibrate the monitor according to local
laws and regulations (at least once a year).
Tips!
To Next Page
Loading...
