Z-EDGE T3P - Taking a Snapshot; Wdr; Screen Saver

-16-
• This cycle is repeated until the car battery triggers the low-power protection,
then the dash cam will turn off, and no motion detection will be triggered
anymore.
• Once the dash cam detects position or speed change by GPS, or vibration/
collision by G-Sensor for more than 3 seconds with normal video recording, it
will exit Motion Detection function and enter normal Loop Recording mode.
• Enable/disable feature:
Main Menu > Settings > Parking Monitor > Motion Detection
4.10 Taking a Snapshot
Tap anywhere on the Screen while recording or in standby mode to bring up
the Shortcuts, and tap the Snapshot ' ' icon to take an instant photo.
4.11 WDR
• Wide dynamic range (WDR) technology compensates for extreme light and
dark spots, balancing exposure to produce a clear image.
• This feature is particularly useful for night driving where an image can include
both dark spots and extreme light spots produced by street lamps or headlights.
• Enable/disable feature:
Main Menu > Settings > WDR > Off / On
4.12 Screen Saver
• Enable the Screen Saver feature for the LCD display to automatically turn off
and only display current Time on it. This prevents the screen from being a
distraction to the driver.
• This feature can be set to Always On, 1 Min, 3 Mins, 5 Mins.
Set the feature to 'Always On' to keep the screen always on while recording.
• Main Menu > Settings > Screen Saver >
Always On / 1 Minute / 3 Minutes / 5 Minutes
Note:
• Since the dash cam is always on after connecting to your car battery with
the Hardwire kit, it will continue to consume the car's battery.
• In order not to drain the car battery, the dash cam will automatically turn
off after 3 hours of Motion Detection function activated.