The Zapco DSP-Z8 IV II Graphical User Interface (GUI)
You have downloaded this preliminary manual from the web site along with the control
program. If you haven’t installed the program on your computer, you should do that now.
You open the compressed file and click on the installation .exe file. You will see the usual
installation prompts as the program is installed. After the program installation you will see the
driver installation. After the drivers are installed the PC will restart to finish the GUI installation.
Installation process
Below are the screens you will see during the program installation
1.
Click YES to allow the program to install
2.
You can choose to use either
English or Chinese
3.
Close any open programs then click
4.
Click next to create a folder for DSP
NEXT Zapco
To Next Page
Loading...
