37 / 58
Identificazione: MD-AL-GI-00
Rev. 4.0 del 31.01.18 - Applicazione: GID
Manual of 11/06/2019 Rev. 1.8 “User Manual for 3000SP storage inverter”
A faster way to change the menu language is to press the “Menu/Back” key and “OK” key at the
same time.
In the firmware version V1.90, the languages available are Chinese, English, Italian, French,
German, Slovak and Ukrainian; future firmware updates may add additional languages.
8. Date and time
Select “8. Date and time” and press “OK” to enter the menu for setting the date/time. Set the date
and time using the “Up” and “Down” keys, then press “OK” to move to the next digit and confirm.
The date and time are expressed in the format: 20YY – MM - DD HH:MM:SS.
The date and time are shown at the bottom left of the main interface.
The correct setting of this menu is fundamentally important if you want to set the working mode
%Charge (for more information, see section 12 of this chapter).
9. EPS Mode (Emergency Power Supply)
Select “9. Set EPS mode” and press “OK” to enter the menu for setting the EPS mode. The following
screen appears on the display.
Select the menu “1. EPS setting” and press “OK” to enter; use the “Up” and “Down” keys to select
between “Enable EPS” and “Disable EPS”, then press OK to confirm.
If the Enable EPS option is set, select the menu “2. Set EPS start-up time” and press “OK”; use the
“Up” and “Down” keys to change the digit and “OK” to move to the next one. When the AC voltage is
interrupted, the EPS mode will enter into operation after the set time. This value can be set
between 1 and 999 seconds.
For more information on EPS mode, refer to the appropriate procedure.
10. DRMs0 Control (only for the Australian market)
Select “10. DRMs0 Control” and press “OK.” The display will show “Enter PWD!” Press “OK” to enter
the password “0001” and use the “Up” and “Down” keys to select the digit and “OK” to move to the
next digit. If the display shows “Incorrect, try again!” press the “Menu/Back” key and enter the
password again. When the correct password has been entered, the menu for setting the DRMs0
Control will appear. Select “1. Enable DRMs0” or “2. Disable DRMs0” if you want to enable or
disable this function. Press “OK” and wait for “OK” to appear on the display.
Note: this setting is only used in countries where the Australian standards are in force; it all other
situations, it should be ignored.
To Next Page