107
Printer Configuration and Adjustment
Adjust Printer Settings
8/25/15 ZT400 Series™ User Guide P1066582-003
Maximum Label
Length
Set the maximum label length.
User menu item:
Main Menu >
SETTINGS
Accepted values:
0 to the maximum label length supported by the printer
Important • Specify a value that is at least 1.0 in.
(25.4 mm) greater than the actual label length
plus the interlabel gap. If you set the value to one
that is smaller than the label length, the printer
assumes that continuous media is loaded, and the
printer cannot calibrate.
For example, if the label length is 6.0 inches
(152 mm) including the interlabel gap, set the
parameter for at least 7.0 inches (178 mm).
Related ZPL command(s):
^ML
SGD command used: ezpl.label_length_max
Printer web page: View and Modify Printer Settings > Media Setup >
Maximum Length
Table 5 • Print Settings (Continued)
2
1
Label length (including interlabel gap)
2
Interlabel gap
3
Set the maximum label length to
approximately this value
1
3
To Next Page
Loading...