175
Troubleshooting
Ribbon Problems
8/25/15 ZT400 Series™ User Guide P1066582-003
Ribbon Problems
Table 17 identifies problems that may occur with ribbon, the possible causes, and the
recommended solutions.
For videos of some common procedures, go to http://www.zebra.com/zt400-info.
Table 17 • Ribbon Problems
Problem Possible Cause Recommended Solution
Broken or melted
ribbon
Darkness setting too high. 1. Reduce the darkness setting. See Print
Darkness on page 101 for how to change the
darkness setting.
2. Clean the printhead thoroughly. See Clean
the Printhead and Platen Roller
on page 156.
The ribbon is coated on the
wrong side and cannot be used
in this printer.
Replace the ribbon with one coated on the
correct side. For more information, see Coated
Side of Ribbon on page 23.
Wrinkled ribbon Ribbon was loaded incorrectly. Load the ribbon correctly. See Load the Ribbon
on page 58.
Incorrect burn temperature. For optimal print quality, set the darkness to the
lowest possible setting for your application. You
may want to perform the FEED Self Test
on page 190 to determine the ideal darkness
setting.
See Print Darkness on page 101 for how to
change the darkness setting.
Incorrect or uneven printhead
pressure.
Set the printhead pressure to the minimum
needed for good print quality. See Adjust the
Printhead Pressure on page 147.
Media not feeding properly;
“walking” from side to side.
Make sure that media is snug by adjusting the
media guide, or call a service technician.
The printhead or platen roller
may be installed incorrectly.
Call a service technician.
The printer does not
detect when the
ribbon runs out.
The printer may have been
calibrated without ribbon.
Later, ribbon was inserted
without the user recalibrating
the printer or loading printer
defaults.
Calibrate the printer, this time using ribbon, or
load printer defaults. See Calibrate the Ribbon
and Media Sensors on page 142 or Load
Defaults on page 113.
In thermal transfer
mode, the printer did
not detect the ribbon
even though it is
loaded correctly.
The printer indicates
that ribbon is out,
even though ribbon is
loaded correctly.
The printer was not calibrated
for the label and ribbon being
used.
Calibrate the printer. See Calibrate the Ribbon
and Media Sensors on page 142.
To Next Page
Loading...