Printer Setup and Operation
Install the Printer Driver and Connect the Printer to the Computer—Wireless
90
P1066582-003 ZT400 Series™ User Guide 8/25/15
Connect the Printer to Your Wireless Network
If you wish to use the printer’s optional wireless print server, you must first connect the printer
to your computer using one of the other available connections. While the printer is connected
via one of those connections, you configure the printer to communicate with your Wireless
Local Area Network (WLAN) through the wireless print server.
For additional information about Zebra print servers, refer to the ZebraNet
Wired and Wireless Print Server User Guide. To download the latest version
of this guide, go to http://www.zebra.com/zt400-info.
To connect the printer to your computer by an optional wireless print server,
complete these steps:
1. Install Zebra Setup Utilities as instructed in Install Zebra Setup Utilities on page 62.
2. Connect the printer to your computer using a USB, serial, or optional parallel port as
instructed in Connect a Computer to the Printer’s USB Port on page 71 or Connect a
Computer to the Printer’s Serial or Parallel Port on page 75.
3. Configure the following printer settings. You can change the values through the Zebra
Setup Utilities (click Configure Printer Connectivity on the Zebra Setup Utilities screen)
or by the ways listed at the following links. Contact your network administrator for the
proper values for your network.
• IP Protocol on page 123 (change the value from ALL to PERMANENT)
• Gateway on page 122 (match the gateway value of your WLAN)
• Subnet Mask on page 121 (match the subnet value of your WLAN)
• IP Address on page 120 (assign a unique IP address to the printer)
To Next Page
Loading...