Zebra ZT410 - Final Steps for Tear-Off Mode

Printer Setup and Operation
Load the Media—Tear-Off Mode
38
P1066582-003 ZT400 Series™ User Guide 8/25/15
Final Steps for Tear-Off Mode
1. Slide in the media guide until it just touches the edge of the media.
2. Rotate the printhead-open lever (1) downward until it locks the printhead in place.
3. Does the media that you are using require ribbon for printing? If you are not sure, see
When to Use Ribbon on page 23.
If using… Then…
Direct Thermal media (no ribbon needed) Continue with step 4.
Thermal Transfer media (ribbon needed)
a. If you have not already done so,
load ribbon in the printer. See
Load the Ribbon on page 58.
b. Continue with step 4.
1