137
Printer Configuration and Adjustment
Adjust Printer Settings—Sensor Settings
8/25/15 ZT400 Series™ User Guide P1066582-003
Take Label
Sensor
Set the intensity of the take label LED.
Important • This value is set during sensor calibration. Do not change this
setting unless you are told to do so by Zebra Technical Support or by an
authorized service technician.
User menu item:
Main Menu >
SENSORS
Accepted values:
0 to 255
SGD command used:
ezpl.take_label
Printer web page: View and Modify Printer Settings > Calibration
Table 10 • Sensor Settings (Continued)
To Next Page
Loading...