EasyManuals Logo

Zendure Smart PV Hub 1200 Controller User Manual

Zendure Smart PV Hub 1200 Controller
Go to English
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
3
3.1 Usage
3. SAFETY INSTRUCTION
Smart PV Hub controller doesn’t include a battery pack, and the battery needs
to be purchased separately. For more information about battery AB1000, please
check the user manual of AB1000 .
1. Please check whether SolarFlow is damaged, cracked, liquid leakage, heat or
other abnormalities or cables are damaged before operating. If any, please
stop using the product immediately and contact our customer service.
2. Keep a distance of 50mm between Smart PV Hub and other objects.
3. During the operation of the solar energy system, avoid direct sunlight to
prevent the SolarFlow system from overheating. Do not place the SolarFlow
near any heat source.
4. Do not use around strong static electricity or magnetic elds.
5. It is prohibited to place the equipment in an environment with ammable,
explosive gas, or smoke. Since SolarFlow relies on the shell to dissipate heat,
over-temperature of the shell will lead to damage.
6. Do not attempt to replace the internal components of the equipment by any
unauthorized personnel.
7. Please install the product according to our user manual to avoid damage to
the product or injury to other people.
8. Ensure before nishing installation, the solar cable, the Microinverter canle to
home grid are disconnected.
9. Ensure that Smart PV Hub and Microinverter are installed rmly to avoid
accidents and product damage caused by dropping.
10. SolarFlow has a protection level of IP65, so the product cannot be immersed
in liquids. If the product accidentally falls into water during use, please place
it in a safe and open area and keep it away until it is completely dry. The
dried product should not be used again and should be properly disposed of
according to the disposal guidelines in this manual.
11. Please ensure proper ventilation while in use, inadequate ventilation may
cause permanent damage to the equipment.
12. Do not place anything on the top of SolarFlow, please install it where people
cannot touch it.
Name Add-on Battery AB1000
Model ZDAB1000
Weight 11.5kg
Dimensions 350×200×186.5mm
Capacity 960Wh/48V
Type LiFePO4
Output Power 1,200W Max
Input Power 800W Max
Max Extend Number of Battery 4
Max Extend Capacity 3,840Wh
IP Level IP65
Color Gray
Charging Temperature 0-45℃
Discharging Temperature -20-45℃
Warranty 10 Years
EN

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zendure Smart PV Hub 1200 Controller and is the answer not in the manual?

Zendure Smart PV Hub 1200 Controller Specifications

General IconGeneral
BrandZendure
ModelSmart PV Hub 1200 Controller
CategoryController
LanguageEnglish