804050NZ- CS Commercial HydroTap - Installation Instructions - 09.2016 v3.01 Page 19 of 20
OPEN Position
CLOSED Position
ON
OFF
Stop cock
operation
Commissioning
NOTE: For any subsequent fi lter changes or any operational procedures, please refer to the HydroTap user
guide, located inside the fi lter housing access door.
Trouble Shooting
In order to help preserve our environment we ask that you dispose of this product correctly. Please contact
your local city council for collection centre details.
End of Life Disposal
System Fault
Message
Possible Cause Solutions
Power board fault Electrical disruption Check power supply and all fuses
Interface fault Internal fault Call Zenith Service
Level board fault Internal fault Call Zenith Service
Condenser screen blocked Blocked Air filter Remove blockage / Clean filter / check user guide
Water leak, Isolate mains Water leak Turn off mains water supply / Call for service
Compressor over-run Compressor too Hot Check ventilation
Water supply failed No water Check water supply is turned ON
Cold sensor Open Internal fault Call Zenith Service
Cold sensor Closed Internal fault Call Zenith Service
Flood sensor Open Internal fault Call Zenith Service
Condenser sensor Closed Internal fault Check Ventilation / Call Zenith Service
Condenser sensor Open Internal fault Check ventilation / Call Zenith service
Compressor driver fault No chilled water Call Zenith Service
Condenser overtemp. Blocked air filter Remove blockage / Clean filter / check user guide
A DC Pump is faulty Internal fault Call Zenith Service
Comp Fuse/Driver Fault Internal fault Call Zenith Service
Flash Mem corrupted Internal fault Call Zenith Service
Flow Sensor Fault Internal fault Call Zenith Service
Call an electrician, a plumber, or Zenith on
0800 558055
for assistance, service, spare parts or enquiries.
To Next Page
Loading...
