11
2. Press the ON/OFF button on the front of the unit to turn ON the
ZX-20.
3. Press the ON/OFF button four times, this will open up the settings
menu. Press the shoot/record button to activate the settings page.
4. Press the ON/OFF button three times, this will open up the ZX-20
hardware settings menu.
5. Press the down button twice on the right side of the unit to navigate
down the menu to ‘Format’.
6. Press the shoot/trigger button again to open the Format section.
7. Press the up/down button again to select either ‘confirm’ or ‘cancel’,
this will initate the formatting of the Micro SD card.
NOTE: Formatting the Micro SD card will permanently erase all the data that
is currently stored on it. Be sure to back up any content that is currently
saved on it prior to formatting.
To Next Page
Loading...
