25
1. Press the ON/OFF button four times, this will open up the settings
menu. Press the shoot/record button to activate the settings page.
ZX-20 video settings is the first menu that comes up
2. Resolution is the first setting on the list, you will see this highlighted.
Press the shoot/record button to open up this setting.
4.
Press the
up/down button
to the option you require, you will see this
highlight. To select this option, press the shoot/record button.
5.
To exit the settings, press the ON/OFF button four times, you will
be prompted to press the shoot/record button to confirm exiting.
8.3 LOOP RECORDING
The loop recording function allows for the ZX-20 to record
continuously, using footage intervals of 2, 3 or 5 minutes. When the
loop recording function is activated the ZX-20 will delete the oldest
recorded loop file and replace it with the newest file when the SD card
is full.
If the loop recording is set to OFF, the ZX-20 will record continously
for one hour, as a single file. The ZX-20 default setting is 5 minutes.
To change either the loop recording interval or to turn OFF loop
recording, follow the below steps:
1. Press the ON/OFF button four times, this will open up the settings
menu. Press the shoot/record button to activate the settings page.
ZX-20 video settings is the first menu that comes up
To Next Page
Loading...
