23
2. Press the ON/OFF button once, this will open up the ZX-20 photo
settings menu.
3. Press the down button two times to navigate down to ‘Continuous
photo mode’, you will see this highlighted. Press the shoot/record
button to open up this setting.
4.
Press the
up/down button
to the option you require, you will see this
highlight. To select this option, press the shoot/record button.
5.
To exit the settings, press the ON/OFF button three times, you will
be prompted to press the shoot/record button to confirm exiting.
7.5 BURST MODE
Take multiple photos in quick succession when you use the ZX-20. You
can change between: 3 photos/sec, 5 photos/sec, 10 photos/sec and
OFF. The ZX-20 default setting is set to OFF. To change follow the
below steps:
1. Press the ON/OFF button four times, this will open up the settings
menu. Press the shoot/record button to activate the settings page.
2. Press the ON/OFF button once, this will open up the ZX-20 photo
settings menu.
3. Press the down button three times to navigate down to ‘Burst
mode’, you will see this highlighted. Press the shoot/record button
to open up this setting.
To Next Page
Loading...
Need help?
General
