15
6.6 SETTING THE DATE
To set the correct date on your ZX-30, follow the below steps. Please
note, you will need to set the time and date in separate settings.
To access the system settings for the ZX-30 follow the below steps:
1. If you are currently in VIDEO MODE and RECORDING, you
will need to PRESS the SHOOT/RECORD BUTTON to end the
recording first.
2. PRESS the
BUTTON on the bottom right of the screen, this
will open up the SETTINGS MENU. A pop up with two locks and
arrows may appear. Swipe from left to right. You may need to
PRESS the
BUTTON again.
3. PRESS the
tab on the left side of the screen. The current
section tab will be highlighted blue.
4. Scroll down the list by swiping from bottom to top until you
reach DATE SETTING. PRESS on this option. The DATE SETTING
screen will pop up.
5. You will be prompted to fill in the current year, month and day.
Navigate through by pressing on either year, month and day on
the screen. To change the numbers PRESS the up and down
arrows on the screen until you reach the required number.
6. Once you have adjusted the date, confirm this by pressing the
tick on the screen in the top right corner. The time will now be
updated.
To Next Page
Loading...
Need help?
General
