43
8.0 RESTORE DEFAULT SETTINGS
This setting will restore the ZX-30 to factory default. All setting
adjustments made to the unit will be erased.
If you need to restore to factory settings, follow the below steps:
1. If you are currently in VIDEO MODE and RECORDING, you
will need to PRESS the SHOOT/RECORD BUTTON to end the
recording first.
2. PRESS the
BUTTON on the bottom right of the screen, this
will open up the SETTINGS MENU. A pop up with two locks and
arrows may appear. Swipe from left to right. You may need to
PRESS the
BUTTON again.
3. PRESS the
tab on the left side of the screen. The current
section tab will be highlighted blue.
4. Scroll down the list by swiping from bottom to top until you reach
RESTORE DEFAULT SETTING. PRESS on this option. You will
be prompted to either confirm or cancel. PRESS the option you
require.
Once the ZX-30 factory reset has been confirmed, the unit will turn
off. You will need to turn on the unit again by pressing the ON/OFF
BUTTON.
To Next Page
Loading...
Need help?
General
