23
6.14 LED INDICATOR
The ZX-30 has LED indicator lights that allow you to see if a function
is active. The LED indicator is on the top of the unit and notifies you
when WiFi is connected by an orange light. There are also two small
LED indicator lights on the left side of the screen;
• The RED LED indicator light shows the ZX-30 is charging.
• The BLUE LED indicator light will stay solid blue when not recording,
and when recording will flash BLUE.
The ZX-30 default setting is set to ON. To change this setting, follow
the below steps:
1. If you are currently in VIDEO MODE and RECORDING, you
will need to PRESS the SHOOT/RECORD BUTTON to end the
recording first.
2. PRESS the
BUTTON on the bottom right of the screen, this
will open up the SETTINGS MENU. A pop-up with two locks
and arrows will appear. Swipe from left to right. You may need to
PRESS the
BUTTON again.
3. PRESS the
tab on the left side of the screen. The current
section tab will be highlighted blue.
4. Scroll down the list by swiping from bottom to top until you reach
LED INDICATOR. You will notice there is a small box with a tick
on it and TURN ON next to it. PRESS the box to deactivate this
function. It will now say TURN OFF.
To Next Page
Loading...
Need help?
General
