Safety principles of working with the three-point hitch
Persons that are not authorized to work with the attached implement must not stand between
the tractor and the hitched machine (implement) - (A). Do not park the tractor with an attached
implement in the lifted position (B). During a drive without an implement the lower draw-bars (5) must
be connected with springs and the upper draw-bar (1) must be inserted into the spring suspension!
During transport of implements the limiting draw-bars (4) of the lower draw-bars must be adjusted in
such a way to avoid unwanted lateral movement of the implement!
FCL20S5028
Height adjustment of the lifting draw-bars
Fixed and free position of the lower hydraulic draw-bars
Lifting draw-bar - see fig. (A)
After disconnecting the upper end of the lifting draw-bar
from the pin of the hydraulic arm make the adjustment by
turning the lug (1).
Lifting draw-bar - see fig. (B):
Extend the capstan (2) in the arrow direction and make
the adjustment by turning the capstan.
Depending on the equipment of the tractor both the draw-
bars may be designed as in fig. (B).
PGPPN086
Fixed position of the lower hydraulic draw-bars (A):
The pin head (1) and washer (2) are installed horizontally.
Free position of the lower hydraulic draw-bars (B):
The pin head (1) and washer (2) are installed vertically.
The free position enables free connection of the tractor
and implement. In this case both the draw-bar ends may
move freely against each other as regards their height.
PCLPN087
To Next Page
Loading...
