Limiting draw-bars
*Lower draw bar with slipping out end pieces
*Lower draw bar with CBM hooks
Securing lower draw bars with CBM hooks
The limiting draw-bars - stabilizers (1) limit or completely
prevent lateral swinging of the lower draw-bars. The
adjustment of the left and right limiting draw-bar is
performed by turning of the draw-bar pipe, see arrow.
Both the limiting draw-bars must always be
installed on the tractor.
F18N112
Lower draw bar of linkages are equipped with semi-
automatic protruding CBM end pieces. They enable
connecting of tools behind a tractor. After protruding
securing pegs (1) slip the end pieces out (2). Slipped-out
end pieces are attached to tightening pins of mounted
tools.
After connecting the mounted tools, release the arms of
hydraulics. By lowering them down and reverse travel of
a tractor, endpoints (2) are slid onto draw bars and
automatically are locked in working position by means of
locking pegs (1).
Always check the position of slipped-out end
ieces and lockin
pe
s, see fi
.
3
E459
Both the lower (3) and upper (4) hitch links are equipped
with CBM hooks.
The implement must first be fitted with CBM balls (1) and
the distance between the lower hitch links (3) must be
adjusted with the stabilizer bars.
When reversing and subsequently lifting the three-point
hitch, its lower links (3) are attached to the implement and
then the upper link (4) of the three-point hitch is attached
by the driver.
To disconnect the implement, release the hooks by the
control cables (2), lift the upper link (4) and disconnect the
lower link (3) by lowering the three-point hitch.
PCLPN089
For extremely demanding working conditions
(aggregation with heavy machinery on slopes or with
aggregation side faced machines) we recommend
safely locking the hook of lower draw bar by inserting
a M8 screw to (S) hole and locking the screw with
a pad.
C18N127
To Next Page
Loading...
