Quick Reference
Q-2
USER PROGRAMMING COMMANDS
110# uu# Disable User Number “uu” (default)
111# uu# Enable User Number “uu”
122# uu# ee# Tone Translation (uu = user, ee = encode to use)
(default, encode is the same as decode)
120# uu# Encode Disabled During TX-Hold for User “uu” (default)
121# uu# Encode Enabled During TX-Hold for User “uu”
123# uu# Use Normal TX-Hold Timer for User “uu” (default)
124# uu# Use Alternate TX-Hold Timer for User “uu”
130# uu# Reserve Mode Disabled for User “uu” (default)
131# uu# Reserve Mode Enabled for User “uu”
150# uu# Courtesy Tone Disabled for User “uu” (default)
151# uu# Courtesy Tone Enabled for User “uu”
99# Exit Program Mode
To Next Page
