7
Page 8
Brief operation instructions
Switch on the device at the mains connection
switch. The mains connection
display lights up, and after self-testing an acoustic signal is produced and then
the software version number is displayed. Micro 5 is ready for use.
Direct the radiator head at the part of the body to be treated, or place it
directly on the part. Make sure that the radiator head setting is correct for the
part of the body to be treated.
Follow the instructions for positioning the radiator head when doing this.
Press the start/stop button.
Preselect “unpulsed” or “pulsed” treatment form and pulse frequency if
applicable.
Preselect treatment time.
Start treatment by increasing the intensity control setting.
Comply with the dosage guidelines when doing this.
An acoustic signal is produced at the end of the preset treatment time.
Intensity returns to zero.
Comply with the warnings in these instructions for use!
To Next Page
Loading...
