Zimmer Micro 5 - Safety and Maintenance

Safety and maintenance
14
Page 18
Micro 5 is manufactured according to the DIN EN 60601
-
1 safety regulations.
As the manufacturer, Zimmer MedizinSysteme GmbH can only consider itself to be
responsible for the safety and reliability of the device if
 the device is operated using a proper power outlet with earth contact and the
electrical installation complies with DIN VDE 0100 part 710,
 the equipment is operated in accordance with the instructions for use,
 extensions, readjustments or modifications are carried out only by persons
authorised by Zimmer MedizinSysteme GmbH,
 the user has confirmed the functional safety and the proper operating condition
of the device before use,
 the device is operated only by properly trained personnel.
 the device is not operated in hazardous areas and / or a combustive
atmosphere,
 the device is immediately disconnected from the mains when penetrated by
liquid.
The device does not contain any parts that can be repaired by the operator.
Fuses and other spare parts may be replaced only by trained service staff.
Device service may only be performed by trained staff. All descriptions required for
service can be seen in the Micro 5 service manual or can be requested from the
manufacturer. Upon request, Zimmer MedizinSysteme will provide wiring diagrams,
lists of components, descriptions, calibration instructions or other documents.