Zimmer Micro 5 - EMC Declaration

Manufacturer´s EMC declaration
18
Page 22
Medical electrical devices, such as Micro 5, are subject to special precautionary measures with regard to
EMC (electromagnetic compatibility) and must be installed and put into operation according to the EMC
information in the instructions for use or accompanying documentation.
Portable and mobile HF communication devices (such as mobile phones, cell phones) can affect medical
electrical devices.
Micro 5 may only be operated with the original power cable indicated in the list of the scope of delivery and
accessories.
Operation of the device with a different power cable can lead to increased emissions or reduced interference
immunity of the device!
Guidelines and manufacturer's declaration
–
Electromagnetic emissions
The Micro 5 device is intended to be operated in an electromagnetic environment as indicated below. The customer
or user of the Micro 5 should ensure that it is operated in such an environment.
Interference emission measurements
Compliance
Electromagnetic environment
-
Guideline
HF emissions according to CISPR 11
Group 2
The Micro 5 device must emit electromagnetic
energy to guarantee its intended function.
Electronic devices in the vicinity may be
impeded.
HF emissions according to CISPR 11
Class B
The Micro 5 device is suitable for use in all
facilities, including those in a residential area,
and in those which are connected directly to
the public grid which also supplies buildings
used for residential purposes.
Harmonic emissions according to IEC
61000-3-2
Class A
Voltage fluctuations/flickers according to
IEC 61000-3-3
Complies
The device should not be used in the direct vicinity of or stacked with other devices. If operation near or
stacked with other devices is necessary, the device should be observed to check its proper operation in
the arrangement used.