Troubleshooting
Disposal
17
Page 21
display is not lit
although the device is
switched on.
Make sure that power is supplied to the power outlet.
Check the plug connections on the device and power outlet.
Check fuses on the rear of the device.
feel any heat.
Check that the device has been installed correctly in accordance with chapter
instructions for use. Then perform a functional test in accordance with chapter 15.
Notify customer service of any malfunction.
If a fault condition is detected during the self
tests carried out continuously during operation,
a fault number preceded by the letter “F” appears on the power display. Current treatment is
interrupted, the device emits a warning tone, and all operating elements are blocked.
Occasionally, the error can be corrected by switching the device off and back on.
If that does not resolve the matter, contact customer service.
The device is about to overheat
Switch off the device. Then switch the device back on and wait for approximately 2 minutes
without activating the intensity controller. Operation should be possible again after this time.
If that does not resolve the matter, contact customer service.
out of service and contact customer service.
If any other problems occur or other fault messages appear, take the device out of
service and contact customer service.
It is essential that you notify technical support / customer service
that occur frequently or cannot be resolved.
You may get in touch with them via your sales representative or via the main office in
Neu-Ulm.
Zimmer MedizinSysteme GmbH
Junkersstraße 9
89231 Neu-Ulm
Tel. +49 731 / 9761-291
Fax +49 731 / 9761-299
export@zimmer.de
www.zimmer.de
The device may only be returned to the factory in its original packaging. It must be
disposed of by the factory in Neu-Ulm.
In foreign (European) countries please refer to national regulations for disposal.
Contact your distributor if necessary.
To Next Page
Loading...
