Why is the compressor over-running on my Zip Water Filtration Systems?
If your Zip Water Filtration System's compressor is over-running, this could be because the compressor is too hot. Ensure that the unit has adequate ventilation.
What to do if my Zip Water Dispenser compressor is over-running?
If the compressor in your Zip Water Dispenser is over-running, check the ventilation to ensure it's adequate.
What to do if my Zip Water Filtration Systems shows condenser overtemp.?
If the condenser on your Zip Water Filtration System is overheating, it's likely due to a blocked air filter. Remove any blockage and clean the filter. You may also consult the user guide for detailed instructions.
Why does the compressor in my Zip Water Filtration System over run?
If the compressor in your Zip Water Filtration System is running excessively, ensure that the ventilation is adequate.
Why is the condenser overheating in my Zip Water Filtration System?
If the condenser of your Zip Water Filtration System is overheating, it's likely due to a blocked air filter. Remove any blockage, clean the filter, and consult the user guide for further instructions.
What to do if there's a water leak in my Zip Water System?
If you detect a water leak, immediately turn off the mains water supply. You may also need to call for service.
What causes condenser overtemp in Zip HydroTap G4 Water System?
If the condenser of your Zip Water System is experiencing overtemperature, this is likely due to a blocked air filter. Remove any blockage and clean the filter. Refer to the user guide for detailed instructions.
What to do if there is a water leak in my Zip Water Filtration System?
If your Zip Water Filtration System experiences a water leak, immediately turn off the mains water supply and call for service.
What to do if the water supply failed on my Zip Water Filtration Systems?
If your Zip Water Filtration System is experiencing a water supply failure, it's likely due to the water supply not being turned ON. Ensure that the water supply is turned ON.
What to do if the boil dry protection is activated in Zip Water Filtration Systems?
If your Zip Water Filtration System's boil dry protection has activated, it's likely due to the safety mechanism being triggered. To reset, turn the power OFF and then ON again.
General| Model | HydroTap G4 |
|---|---|
| Category | Water System |
| Power Supply | 220-240V, 50Hz |
| Dimensions | Varies by model |
| Weight | Varies by model |
| Boiling Water Capacity | Up to 160 cups per hour |
| Filter | Advanced filtration system |
| Safety | Child safety lock |
| Filtration | 0.2 micron |
| Energy Efficiency | Energy-saving mode |
| Warranty | 5 years |
| Chilled Water Capacity | Varies by model (e.g., up to 175 cups/hour) |
To Next Page
